Universal 360 Transducer Mount
Our MEGA Mount is designed to work with Humminbird's MEGA 360 transducer. However the first generation 360 transducer shaft will fit.
Note that the shaft length's are different from Humminbird on the MEGA vs. the first generation 360 (shorter). Be sure to measure to ensure the shaft will work with your hull.
Users are also adding shafts to our MEGA Mount to use Garmin's Panoptix Live Scope.
If you are doing this our clamp arm opening is 1.130" in diameter and the factory shaft is about 1.127" (1 1/8").
No shaft or transducer is included and we do not carry shafts at the moment. You can source them locally in your home country. The reason being is that there are so many different shaft lengths from kayaks to center consoles, with different strength requirements for each application.
The base is 4" in diameter, the vertical arm is 8" long and the clamp arm is just over 10.5" long. The base is interchangeable with our Pro Mount and Pro Mount Base allowing users to move electronics and the MEGA Mount around the boat as required.
We use our proprietary locking tooth system to ensure that this mount stays where you set it. We include a stop ring to reduce the risk of the shaft sliding through the clamp arm.
Check out the raw unedited video below to see our very early testing on one of our test boats 5 months before the release of the product. The MEGA mount has been through harsh on boat, machine, and salt water testing during that period. We do this to ensure that we put out the best product that we are able to.